Rafter & Stair Layout help
Answers for framers and roofers using Rafter & Stair Layout (Framing Calc under the icon). If your question is not here, write to us and say which screen you were on.
Rafters and roofs
My rafter length is a little off from my framing square. Which one is right?
The app gives the line length from the center of the ridge, then takes half the ridge thickness off, the same way a ridge deduction works on the square. Check that you entered the full building span (not the run) and the real ridge thickness, usually 1-1/2" for a single 2x board. Open How this is calculated under the result to see each step.
What do the hip side cuts mean?
The hip side cut is the cheek cut where the hip meets the ridge, given both as numbers to set on your square and as an angle for the saw. The jack side cut is the one on the top of each jack rafter. The list under the result has every jack length at the spacing you picked.
How many squares and bundles do I order?
The Roof squares screen takes the roof's plan size with the overhangs included. One square covers 100 square feet of roof. Bundles assume three to a square unless you change it. Add your own waste percent; 10% suits a plain gable, and hips and valleys usually want 15%.
Stairs
Why does my stair fail?
Each row under the stair result is one IRC 2021 R311.7 rule with its section number. A riser over 7-3/4" fails, so does a tread under 10", a difference of more than 3/8" between the tallest and shortest riser, or one flight rising more than 151" without a landing. Most of the time one more riser fixes it.
My town uses different stair rules.
Open Settings with the gear on the home screen and fill in Tallest riser allowed and Shallowest tread allowed. The stair checks then use your numbers and mark those rows as local code. Clear the fields to go back to the IRC numbers. Your building department has the final word.
Where do I mark the stringer?
The cut points list gives the run and rise of every notch, measured from the bottom of the stringer. The throat line tells you how much wood is left under the deepest notch, so you can see if a 2x12 is enough.
Fractions and the tape
How do I type 12' 6-3/4"?
On the tape screen tap 1, 2, ft, 6, the fraction dash key, 3, /, 4 and in. Any length field takes the same text, and metric works too: 3.2m or 950mm. Pick how fine answers round, from 1/2" to 1/32", in Settings under Tape marks.
Can I keep a job for later?
Tap the bookmark at the top of a calculator and give it a name. Saved jobs on the home screen opens it again with the same numbers. To send numbers to your crew, tap the share button: it sends plain text.
I switched phones and my jobs are gone.
Saved jobs live inside the app on the phone. They come across when you set up the new iPhone from a backup of the old one. There is no account, so there is nothing to sign in to.
Contact
Write to dmitry@antonyuk.org. If a number looks wrong, send the inputs you typed and what you expected.